How to Roll a Joint

Every now and then you may want to to light up a spliff but need to keep it on the downlow. These secret agent joints look just like regular cigarettes so nosey passer bys wont suspect a thing. Say hello to the secret agent...

How to Easily Roll a Secret Agent...

Rolling Papers
Lick and stick two rolley papers together by attaching the gummed strip of one to the edge of the other paper.

 

 

 

 

Dismantling the Cigarette
Grab a cigarette and take out the filter from the butt by squeezing it firmly at the base and rotating it arount the filter with your fingers and thumb. It should eventually poke out just enough for you to grab it and yank it out.

 

 

 

 

Replacing the Filter
Roll yourself a roach around about the same size as the filter you just took out and shove it in.

 

 

 

Cutting the Cig
Get a sharp knife (a stanley knife is preferable) and cut the cigarette approximately one centimetre from the roach.

 

 

Replacing the Tobacco
Now lay a paper out underneath your new disguised roach and roll enough mix down on the paper to look like the shape of cigarette. Try to keep it relatively circular.

 

 

 

Roll it Up!
Carefully roll the joint into an even cigarette shape with the disguised filter poking out the end.

 

 

 

 

Tighten it up
It may feel a bit loose and not connected well. If this is the case rip of the gum strip of another paper and wrap it around between the roach and the paper to seal it better. Then your secret agent joint is all done!

 

 

 

 

 

Other Cool Joints...

 

If you thought this joint was cool then why don't you check out our how to roll a Joker Joint page.
If you are new to joint rolling then take a look at the basics at how to roll a joint.